Things to pay attention to when applying rivet air compressor

 

When using a rivet air press, if you do not pay attention to relevant matters, it is easy to cause riveting defects and even cause mechanical failure. Therefore, every operator must accurately grasp the key points of riveting. The following is a detailed introduction to the key points of riveting. Pay attention to the ten specific points. I hope that the content of the article will be a reference for everyone.

 

1. It is not allowed to produce and process product workpieces that are beyond the standard scope of rivet air compressor equipment.

 

2. The equipment cannot work under high pressure for a long time.

 

3. The extended length of the rivet head must not exceed the specified range.

 

4. If you encounter any abnormality, you must immediately stop the vehicle for repairs. If the fault is not cleared, the machine cannot be started and operated.

5. The slide rails of the machine should be wiped with unsalted butter once every month to ensure that they can be lubricated and prevent rust.

 

6. When assembling and disassembling the rivet head, the posture should be gentler and not too strong. Especially when disassembling the rivet head, you should not use force to pull it out. When disassembling, you should still turn the rivet head and slowly pull it out. out.

 

In the case of pulling out, once the rivet seat is pulled out of the normal position, it will be found that there will be a large error in the rivet head after using the rivet head. At this time, the bright red protective cover should be disassembled and assembled to ensure that the rivet head The rivet seat must be assembled in time and then used. If the rivet seat is offset, failure may occur during use.

 

7. When using a rivet press, if some materials are processed, the rivet head may be slightly bonded. In order to ensure the quality of Sister Bao in the future, the fuse should be cleaned regularly to prevent sticking. The welding is serious, resulting in poor riveting quality.

 

8. Daily maintenance of the equipment should be carried out every two weeks. If any problems are found, they should be dealt with in time: the maintenance items are as follows.

 

A. Check whether the oil in the pneumatic triplet oil gauge is sufficient. If it is not enough, fill the oil gauge.

 

B. Check the connection firmness of each gas valve and tee joint to see if there is any steam leakage. If there is steam leakage, repair it in time.

 

C. Check whether there is any bonding in the rivet head cavity of the rivet air press. If so, it should be removed.

 

D. Lubricate each curved surface pair.

 

9. Every six months, the system should be comprehensively inspected and repaired in batches. The items to be inspected include the sealing condition of the left and right parts of the cylinder, the robustness of each connecting pipe, and the shaking of the rivet head. If Any problems found must be inspected and repaired in a timely manner.

 

10. Maintenance should be undertaken by our staff.